Electric Compressor Instructions

1 Remove the power cable from the RATT RDK case.

2 Remove the power connector cap from the side of the case, then attach the supplied power cable.

3 Connect the 12V male connector to your 12V power source.

4 Remove the 4’ compressor hose from the bag located under the lid of the compressor case.

5 Attach one end of the hose to the hose fitting on the top panel inside the compressor case.

6 Once connected, attach the other end of the hose to the hose fitting at the bottom of the mast.

7 Unlock all sections of the mast before turning on the compressor and extending the mast.

8 Flip the power switch to the ON position. The switch is located on the top panel inside the case.

9 Once the mast is fully extended to the desired height, turn off the compressor and disconnect the hose from the mast.